Whether you build new homes or specialise in remodeling existing homes, installing a Beam Central Vacuum System usually takes only a few hours and a few simple steps. And with Beam's exclusive CleanStream™ Filtration System there's no outside venting required.
 

Determine inlet valve locations. Run PVC pipe and low voltage (24V) wiring from the inlets to the power unit (after plumbing and electrical work is completed and before wallboard is installed). Then mount the power unit.
 

  

Determine locations for inlet valves. Then run PVC pipe and low voltage wiring through the basement, attic or crawlspace to the power unit. (In multi-story homes, piping may be run to upper levels through the backs of closets, under stairways, beside soil pipes.) There's little or no damage to walls and practically no mess. Then mount the unit. Whether it's a new or existing home, your authorized Beam dealer can take care of installation, service and warranties. That is easy!

Beam covers NZ with a network of dealers and trained installers who can help size, install and service Beam systems in your homes. See Distributor Locator for the Beam professional nearest you.